最新中文字幕在线,综合国产第二页,黄色91视频

BYD environmentally friendly electric forklift specifications- Check whether the contact points are worn

The application scenario guarantees the confidence of the product

It is strictly prohibited to load and unload the counterbalanced forklift manually to avoid safety problems 3 tons is a common load specification for electric forklifts, which usually refers to electric forklifts with a load of 3 tons under 1

The lifting device also comes from the motor to drive the hydraulic pump station to push the hydraulic oil inside the hydraulic cylinder to achieve lifting, rising and falling

When replacing the hydraulic oil, make sure that the oil tank is clean, the oil is free of impurities, and the oil is sufficient

The use of explosion-proof equipment can effectively prevent the forklift from dangerous situations such as fire and explosion in an explosion-proof environment

When driving on a larger slope allowed, the operator must keep the cargo on the counterbalanced electric forklift and slow down at the same time, and never accelerate

If it is lower than the limited working voltage, the forklift should stop running immediately

Power Management: Equipped with the world's leading power management system to monitor the battery in real time, perform high-precision calculations on the charge status, ensure that the battery is always working in a safe state, and increase the battery cycle This situation seems to be very good, but it actually reflects a big problem When the electric forklift is operating in the warehouse, it should be avoided that the forklift is driving and lifting at the same time 9 The company has more than 10 years of experience in the research and development and manufacturing of standard electric warehouse forklifts

BYD environmentally friendly electric forklift specifications-

If you don't understand, you can also ask: Forklift manufacturer

, Ltd After the engine is started, it usually has enough warm-up time to operate at low speed and low load until the engine, transmission, hydraulic system and heated oil are finally driven

Its implementation principle is basically the same as that of a general electric forklift, but there are obvious differences in design and component selection

First of all, we must understand the AC motor, the three-phase brush is damaged and malfunctions occur

Its characteristics are: the power form is electric, the operation mode is walking, the load capacity is generally less than 3 tons, the width of the operating channel is generally narrow, and it is mainly used for horizontal transportation and cargo stacking, loading and unloading in the warehouse

Control method: hydraulic control 7

Low voltage protection function protects the battery and extends its service life

When driving indoors, the speed should not exceed 5km/h

This means that electric forklift manufacturers can obtain more energy and greater braking torque in actual use to achieve the purpose of speed operation So, what problems are prone to occur with the plate? What are the symptoms? What are the reasons? Next, the truck manufacturer will tell you about it The lifting device also comes from the motor to drive the hydraulic pump station to push the hydraulic oil inside the hydraulic cylinder to achieve lifting, rising and falling

BYD environmentally friendly electric forklift specifications- Avoid overloading or partial loading of goods

, Hangcha Group Co

The speed should be reduced in narrow passages or curved roads

In order to facilitate communication and expand personal connections, we have created five major industry logistics circles

And the magnetic density is higher

In response to the above problems, the safety inspection plan proposed in this section is as follows: Loading device: ① It is designed with a pallet positioning device and a cargo size over-limit sensor, which will issue an alarm signal when the cargo width, length, or height exceeds the limit; ② It is designed with a cargo overweight sensor, which will issue an alarm signal when the cargo is overweight; ③ It is designed with a cargo position over-tolerance detection sensor and a sensor for judging the presence or absence of cargo

Prevent such accidents from happening again! 1

If necessary, use a soft, lint-free, clean white towel to clean the carbon powder on the surface of the phase change groove and the motor commutator

Turn the accelerator forward to move the forklift forward, turn the accelerator backward to move backward, and return the accelerator to the middle position to stop

The market sales are increasing year by year

In this regard, the customer had tried to install only a single-motor drive axle, but this did not solve the problem because the single-motor drive could not reach the same power level as a traditional internal combustion forklift

When the electric pallet truck approaches the fixed place where the goods are placed, slowly lower the forks to ensure the stability of the goods

On the basis of primer spraying, the iron plate of the body can be sprayed with a low-temperature rust-resistant protective layer to cope with the huge temperature difference in the storage operation

New energy forklift leader

Product

BYD Counterbalanced forklift

BYD Warehouse Forklift

BYD large tonnage forklift

BYD tractor truck

Core Features

High security

high performance

High efficiency

High Match

Low overall cost

Super fast charging

Ultra-long life

No charging room required

About Us

Product

BYD Forklift

Contact Info